|
814238-4. OperationAuto , Heat , Dry , Cool , FanModels that only provide the cooling function cannot operate in the auto or heating modes.Power: Turn on the power of the indoor unit at least 14 hours before operation.1. Press .2. Press and select from among Auto , Heat , Dry ,Cool and Fan .3. Press and select the desired speed.If set to Auto , the fan speed switches automatically.(Auto does not work when in the Fan mode.)4. Press one of the buttons and set the desired temperature.Temperature settings cannot be made when in the Fan mode.Stop: Press .When the unit is stopped with the remote controller, the fan on the outdoor unit may continue to run for a while, eventhough the compressor of the outdoor unit stops.If the unit is not heating very effectively with a Low fan speed , switch the fan speed to High or Medium.Depending on the indoor unit being used, it may indicate a function that it does not have. (The fan speed is set.)If you cannot turn the air conditioner off in the normal way.Disconnect the power to the indoor unit and contact the dealer where the product was purchased.Only when identical refrigerant system inside all the indoor units or cooling/heating free-type are under control as one group.It heats or cools automatically via the differences between the set temperature and the room temperature.Depending on the indoor unit used, the remote controller may have a [Dry] indicator on its displayeven though the unit does not have the Dry function. (Same as cooler operation)When the room temperature approaches the temperature setting, the unit continues to start up or stop automatically.When the drying mode stops operating, the indoor unit’s fan blows a gentle breeze in order to keep the moisture fromreturning to the room at a minimum.Depending on the indoor unit used, and/or the temperature in the room, the fan speed may not be adjustable.Depending on the unit used, when the outside air temperature is 15 °C or less, the dry function will not operate.MAX MINAuto 27 17Heat 30 16Dry / Cool 30 188-6
|
