Panasonic S-200PE2E5 Technical Data & Service Manual

Also see for S-200PE2E5: Technical data & service manual Operating instructions Technical data & service manual Technical data & service manual Operating instructions

Contents

Panasonic S-200PE2E5 Technical Data & Service Manual Manual pdf 175 page image

8Point the transmitter of the remote controller at the receiver. When the signal is received correctly it will beep once.(It beeps twice only when the unit starts operating.)The signal can be received at a distance of about 6 meters. This distance should be used only as a guide.It depends on battery strength.Make sure nothing is between the remote controller and the receiver that could block the signal.Do not leave the remote controller in direct sunlight, where the wind from the air conditioner can blow directly on it, or nearany other heat source.Take care not to drop, throw or wash the remote controller with water.The signal from the remote controller may not be received in rooms with rapid start fluorescent lighting, inverter lights, plasmadisplays, LCD televisions (monitor), etc. For more information, please contact the dealer where the product was purchased.12Fasten the remote controllerholder with screws.Fitting the remotecontroller in the holder.Remote controller holderPressPut inChecking AddressesWhen you press on the remote controller, its current address appears on the display. If this address corresponds to theaddress of a receiver, the buzzer sounds. (If it is on ALL, the buzzer will always sound.)If it is on ALL, it can be operated regardless of receiver addresses. Point the remote controller at the receiver you wish tooperate and transmit.8-8. Using the Remote ControllerWall Mount Use• Press from the location you wish to mount the remotecontroller and make sure the signal is received properly.• Pull the remote controller forward to remove it.Don’t get the remote controller too far away from the receiver.This may cause a malfunction. Be sure to keep the remote controller in the same room as the receiver.compatible wireress remote controller, addresses can be set up to avoid crosstalk. By setting the address switches on thereceivers and matching them with the number of addresses on the remote controller, up to six indoor units can be controlledseparately with the remote controller. (When using units in a flexible combination or operating multiple units simultaneously,they cannot be controlled individually as they are operated at the same time.) There are separate address settings: receiveraddresses for the receivers and transmitter addresses for the remote controller.For more information, please contact the distributor where the product was purchased.8-9. For Best ResultsPoint the remote controller at the receiver.When the signal is received properly, it will beep one time.Avoid locating the remote controller where it is covered, such as behind a curtain.Keep it out in the open.In both multi and single unit installations, when more than one indoor units are installed in the same room with a8-10. Addresses• These settings are saved in nonvolatile memory in the remote controller, so even when its batteries are changed, the settingsdo not have to be made again.8-9