Panasonic SC-CH55 Operating Instructions Manual

Also see for SC-CH55: Operating instructions

gHowtoinstalltheLW/MWloopantennaScrews (included)wwRear panel | |w/w antenna holder yof the unit | (included) ;To minimize noise pickup, keep the loop antenna away from thespeaker cable, power cord and metal surfaces.LW/MW outdoor antenna (not included)An outdoor antenna may be required in a moutainous region, or ifthis system is located inside a reinforced-concrete building, etc.Run 5 to 12 m of vinyl-covered wirehorizontally along a window or otherconvenient location.5-12 m(16-40 ft.)3 Connect the external unit.When using a turntable system, connect the stereo connectioncable to the input terminals as shown below.TURNTABLEStereopin cordREC OUT © ©PHONO(R) (L)@ “GND”terminalThis terminalis forusewithturntableswhich haveagroudwire.@ “REC OUT”terminalThis terminalisusedtoconnectthissystemtoother cassette deckyou have.Source fromthissystemcould be recorded through yourCassette deck.@ Surround speakersSURROUNDSPEAKERS4 Connect the speaker cable.Match the two wires from the left and right speaker cables withthe same colored levers of the speaker terminals, then insertthe wires into the respective terminals.Connection of speaker cables@® Pull out the outercovering, and twist the -§——==E_ 9center conductor. 15 mm(1%2")@ Tit the lever back andinsert the wire.@ Close the lever and pullthe wire gently to be surethat it is secured.Notes:©To prevent damage to circuitry, nevershort-circuit position (+) and negative(—) speaker wires.©Be sure to only connect positive (+)wires to positive (+) terminals, andnegative (—) wires to negative (—)terminals.®Connections of speaker cables should be made beforeconnecting the AC power supply cord.5 connect the AC power supply cord after allother cables and cords are connected.