Panasonic SC-PM91D Operating Instructions Manual

Also see for SC-PM91D: Owner's manual

23RQT7932The radioManual tuning1Select “FM” or“AM”.2Select thefrequency of thedesired station.3Adjust thevolume.• Press and hold [t] or [y] until the frequency starts scrolling to start automatic tuning. Tuningstops when a station is found.“ST” is displayed when a stereo FM broadcast is being received.If noise is excessive in FMPress [PLAY MODE] to display “MONO”.To cancel, press [PLAY MODE] again.The mode also cancels when you change the frequency.QUICK REPLAYSTOPALL DISCGROUPQUICK OSDFUNCTIONSH.BASS SOUNDSUBWOOFERCM SKIPDISC■ FM frequency step (main unit only)The step is factory-set to 0.2 MHz, but you can change it to receivebroadcasts allocated to 0.1 MHz steps.1.Select “FM”.2.Press and hold [TUNER/AUX] on the main unit.After a few seconds the display changes to show the currentminimum frequency. Continue to hold the button down. The minimumfrequency changes and the step is changed.To return to the original step, repeat the above steps.Any preset stations are cleared by this procedure. Preset themagain.Preset tuningPreset channels to make selection simpler. You can set up to 15 stations each in the FM and AM bands.Tune to the desired station (➡ see above).1Press toselect.(“PGM” appears)2Press while thestation is flashing toselect the channel.The station occupying a channel is erased if another station is preset inthat channel.1. Press [TUNER/AUX] to select “FM” or “AM”.2. Press the numbered buttons or [u2/REW] or [i1/FF] to selectthe channel.Tune to the frequency where presetting is to begin (➡ see above).Press and hold.(release when “AUTO” appears)The tuner presets the stations it can receive into the channels inascending order.When finished, the last station to be set is played.TUNER /AUXNoteSelecting channelsAutomatic presetting Manual presettingThe radio