3 RQT7932Please check and identify the supplied accessories.Use numbers indicated in parentheses when asking forreplacement parts. (As of January 2005)In U.S.A. to order accessories, refer to “Accessory Purchases” onpage 35.System SC-PM91DMain unit SA-PM91DSpeakers SB-PM91Note• The included AC power supply cord is for use with this unit only. Do notuse it with other equipment.• Do not use an AC power supply cord from other equipment.User memo:DATE OF PURCHASEDEALER NAMEDEALER ADDRESSTELEPHONE NUMBERThe model number and serial number of this product can befound on either the back or the bottom of the unit. Pleasenote them in the space provided below and keep for futurereference.MODEL NUMBER SC-PM91DSERIAL NUMBER1 Remote control(N2QAJB000136)1 AC power supply cord(K2CB2CB00006)1 FM indoor antenna(RSA0007-L)1 Antenna plug(K2RC021B0001)2 Batteriesfor remote control1 AM loop antenna(N1DAAAA00001)1 Video cable(RJL1P016B15A)AccessoriesAccessoriesCAUTION:This equipment has been tested and found to comply withthe limits for a Class B digital device, pursuant to Part 15 ofthe FCC Rules.These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequencyenergy and, if not installed and used in accordance withthe instructions, may cause harmful interference to radiocommunications. However, there is no guarantee thatinterference will not occur in a particular installation. If thisequipment does cause harmful interference to radio ortelevision reception, which can be determined by turningthe equipment off and on, the user is encouraged to tryto correct the interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment andreceiver.• Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technicianfor help.Any unauthorized changes or modifications to this equipmentwould void the user's authority to operate this device.This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) thisdevice must accept any interference received, includinginterference that may cause undesired operation.(Inside of product)THE FOLLOWING APPLIES ONLY IN THE U.S.A.