25LSQT1190SetupSetupPower supplyWhen this unit is purchased, the battery is notcharged. Charge the battery before using thisunit.≥ If the DC cable is connected to the ACadaptor, then the battery will not becharged. Remove the DC cable from the ACadaptor.1 Connect the AC cable to the ACadaptor and the AC outlet.2 Put the battery on the batterymount by aligning the mark, andthen securely plug it in.≥ The output plug of the AC cable is notcompletely connected to the AC adaptor jack.As shown in A, there is a gap.∫ Charging lamp≥ Battery charging time (l 26)≥ We recommend using Panasonic batteries.(l 15, 129)≥ If you use other batteries, we cannot guaranteethe quality of this product.Push the battery against the batteryholder and slide it until it clicks.While sliding the BATTERY lever,slide the battery to remove it.≥ Hold the battery with your hand so it does notfall.≥ Before removing the battery, be sure to set theOFF/ON switch to OFF and check that thestatus indicator is off.Charging the batteryLights up: ChargingGoes off: Charging completedFlashing: The battery is over discharged(discharged excessively). In a while,the lamp will light up and normalcharging will start.When the battery temperature isexcessively high or low, theCHARGE lamp flashes and thecharging time will be longer thannormal.AInserting the batteryRemoving the batteryCAUTIONDanger of explosion if battery is incorrectlyreplaced. Replace only with the same orequivalent type recommended by themanufacturer. Dispose of used batteriesaccording to the manufacturer’s instructions.