Others90LSQT1361It is possible that the system cannot complete writing of a file normally when, for example, power isturned off for some reason during recording or editing.If faulty management information is found when the HDD or a card is accessed, one of the followingmessages may appear. Be sure to follow the messages. (Repairing may take time depending on theerror.)≥ When you repair the data, use a battery with sufficient battery power or the AC adaptor. Even if thepower is turned off without repairing the data, you can repair the data when you turn the power onagain.≥ Depending on the condition of the data, it may not be possible to completely repair the data.≥ Do not repair a card that has been recorded on another device. This may cause the loss of data orthe card.CHANGE TO MANUALMODE.You are attempting to use a function that cannot be usedsimultaneously.CANCEL NIGHT VIEWMODE.TURN OFF THE VIDEOLIGHT.OPERATION FAILED.EXCESSIVE SHOCKDETECTED. PLEASE TRYAGAIN AFTER A WHILE.The unit has detected that it is being dropped so the operation hasstopped.INTERNAL TEMPERATURETOO HIGH. PLEASE TURNUNIT OFF AND WAIT AWHILE.The internal temperature of this unit is high so it cannot be operated.Turn off the power, wait until the temperature falls and then turn onthe power again.OPERATION STOPPED.TEMPERATURE TOO LOW.The internal temperature of this unit is extremely low so it cannot beoperated.If “Please Wait.” appears after this message, wait a while withoutturning the unit off. It may take time until the unit can be used.PUSH THE RESETSWITCH.An irregularity in the unit has been detected. Remove the SD cardthen press the RESET button to restart the unit. (l 97)DISCONNECT USBCABLE.The unit cannot correctly establish the connection to the computeror printer. Disconnect and reconnect the USB cable and then selectthe desired USB function again.CANNOT OPERATE WHILEUSB CONNECTED.The unit’s power cannot be turned off when the unit is connected tothe computer.About recoveryHDD ERROR DETECTED. NOW REPAIRING DATA.CARD ERROR DETECTED. NOW REPAIRING DATA.
