Panasonic SDR-H280 Operating Instructions Manual

Also see for SDR-H280: Operating instructions

Contents

Panasonic SDR-H280 Operating Instructions Manual Manual pdf 94 page image

Others94LSQT1361TroubleshootingProblem Check pointsThis unit cannot beturned on.≥ Is the battery fully charged?# Charge the battery using the AC adaptor. (l 17)≥ The battery protection circuit may have operated. Attach thebattery to the AC adaptor for 5 to 10 seconds. If the unit stillcannot be used, the battery is faulty.≥ Is the LCD monitor opened?This unit is turned offautomatically.≥ If you do not use the unit for approximately 5 minutes, thepower is automatically turned off to conserve the batterycharge. To resume recording, turn the power back on.The power will not turn off automatically when the power savefunction (l 85) is set to [OFF].This unit does not stayon long enough.≥ Is the battery low?# If the remaining battery power indication is flashing or themessage “LOW BATTERY.” is displayed, the battery has rundown. Charge the battery. (l 17)A clicking sound is heardwhen the power is turnedoff.≥ This is the sound of the lens moving and is not a malfunction.Battery runs downquickly.≥ Is the battery fully charged?# Charge it with the AC adaptor. (l 17)≥ Are you using the battery in an extremely cold place?# The battery is affected by ambient temperature. In cold places,the operating time of the battery becomes shorter.≥ Has the battery worn out?# The battery has a limited life. If the operating time is still too shorteven after the battery is fully charged, the battery has worn outand can no longer be used.This unit cannot beoperated though it isturned on.This unit does notoperate normally.≥ The unit cannot be operated unless you open the LCD monitor.≥ Remove the SD card then press the RESET button. (l 97) Ifnormal conditions are not restored yet, remove the battery orAC adaptor, wait about 1 minute and then reconnect thebattery or AC adaptor. Then about 1 minute later, turn on thepower again. (Conducting the above operation when theaccess lamp is on may destroy the data on the HDD or card.)The screen has changedsuddenly.≥ Has the demonstration started?# If you set [DEMO MODE] to [ON] without inserting a card invideo recording mode or picture recording mode, the unit isautomatically set to the demonstration mode for introducing itsfunctions. Normally this should be set to [OFF]. Press the MENUbutton, then select [SETUP] # [DEMO MODE] # [OFF] andpress the joystick.