Panasonic TH-152UX1 Operating Instructions Manual

Also see for TH-152UX1C: Service manual

Contents

67891345 2COMPUTERRS-232C Straight cableD-sub 9p(Male)(Female)12SERIAL Terminals connectionNotes:• Use the RS-232C straight cable to connect the computer to the Plasma Display.• The computer shown is for example purposes only.• Additional equipment and cables shown are not supplied with this set.The SERIAL terminal conforms to the RS-232C interfacespecication, so that the Plasma Display can be controlledby a computer which is connected to this terminal.The computer will require software which allows thesending and receiving of control data which satisfiesthe conditions given below. Use a computer applicationsuch as programming language software. Refer to thedocumentation for the computer application for details.The SERIAL terminal is used when the Plasma Display is controlled by a computer.Pin layout for SERIAL TerminalBasic format for control dataThe transmission of control data from the computerstarts with a STX signal, followed by the command, theparameters, and lastly an ETX signal in that order. If thereare no parameters, then the parameter signal does notneed to be sent.STX C1 C2 C3 P1 P2 P3 P4: P5 ETXStart(02h)3-charactercommand (3 bytes)Colon Parameter(s)(1 - 5 bytes)End(03h)Notes:• If multiple commands are transmitted, be sure to wait forthe response for the rst command to come from this unitbefore sending the next command.• If an incorrect command is sent by mistake, this unit willsend an “ER401” command back to the computer.Communication parametersSignal level RS-232C compliantSynchronization method AsynchronousBaud rate 9600 bpsParity NoneCharacter length 8 bitsStop bit 1 bitFlow control -Signal names for D-sub 9P connectorPin No. Details2 R X D3 T X D5 GND4 • 6 Non use78 (Shorted in this set)1 • 9 NCThese signal names are those of computer specications.ConnectionsCommandCommand Parameter Control detailsPON None Power ONPOF None Power OFFIMS NoneSL1SD1DV1HM1HM2PC1Input select (toggle)SLOT input (SLOT INPUT)SDI IN input (4K-SDI)DVI-D IN input (4K-DVI)HDMI 1 input (HDMI1)HDMI 2 input (HDMI2)PC IN input (PC)DAM NoneZOOMFULLJUSTNORMZOM2ZOM3SJSTSNOMSFUL14:9Screen mode select (toggle)Zoom1 (For Video/SD/PCsignal)16:9Just (For Video/SD signal)4:3 (For Video/SD/PC signal)Zoom2 (For HD signal)Zoom3 (For HD signal)Just (For HD signal)4:3 (For HD signal)4:3 Full (For HD signal)14:9With the power off, this display responds to PONcommand only.