17Basic ControlsRemote Control TransmitterStandby (ON / OFF) buttonThe Plasma Display must rst be turnedon at the power switch (see page 13).Press this button to turn the PlasmaDisplay On, from Standby mode. Pressit again to turn the Plasma Display Offto Standby mode.PC buttonPress to select PC IN input.(see page 15)SLOT buttonsPress to select SLOT Terminal Board.(see page 15)SDI button, DVI buttonPress to select SDI IN or DVI-D INinput. (see page 15)SETUP button(see page 34)RETURN button(see page 21)Press the RETURN button to returnto previous menu screen.POS. /SIZE button(see page 22)ASPECT buttonPress to adjust the aspect.(see page 18)VIDEO MENU buttonPress to select Picture Mode.(see page 25)Numeric buttons(see page 32)MEM. LOAD button(see page 32)LIGHT buttonThe remote control’s buttons illuminate.FUNCTION buttons(see page 44)RECALL buttonPress the “RECALL” button to displaythe current system status.1 Input label2 Aspect mode (see page 18)During 3D images (see page 35)Prole name (see page 32)NANODRIFT Saver operating(see page 39)3 Off timerThe off timer indicator is displayedonly when the off timer has been set.Off timer 90123PC4:3Memory name: MEMORY2NANODRIFT3DOFF TIMER buttonThe Plasma Display can be presetto switch to stand-by after a xedperiod. The setting changes to 30minutes, 60 minutes, 90 minutesand 0 minutes (off timer cancelled)each time the button is pressed.30 60090When three minutes remain, “Offtimer 3” will ash.The off timer is cancelled if apower interruption occurs.HDMI buttonsPress to select HDMI 1 or HDMI 2input. (see page 15)PICTURE button(see page 25)OK buttonPress to make selections.Cursor buttonsN button(see page 24, 25, 27)INPUT buttonPress to select input signal sequentially.(see page 15)AUTO SETUP buttonAutomatically adjusts theposition/size of the screen.(see page 22)MonitorNormalCinemaDynamicEXIT buttonExits from Menu screen.