Panasonic TH-42PA20 Operating Instructions Manual

Also see for Viera TH-37PA20: Operating instructions Operating instructions Operating instructions Manual de instrucciones Operating instructions

46ConnectionsPC Input Terminals connectionS VIDEOR - STANDBYG - POWER ON STR F TV/AVAV3VIDEO L R/ /S VIDEOAV3VIDEO L RCOMPUTERConversion adapter(if necessary)RGBD-sub 15pPC cableFerrite core (large size)(supplied)Less than4" (10 cm)Less than4" (10 cm)Notes:(1) Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and verticalscanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)(2) The display resolution is a maximum of 640 × 480 dots when the aspect mode is set to “4:3”, and 852 × 480 dotswhen the aspect mode is set to “16:9”. If the display resolution exceeds these maximums, it may not be possibleto show fine detail with sufficient clarity.(3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible,you will need to make setting changes to the computer at the time of connection.(4) Some PC models cannot be connected to the set.(5) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.(6) The computer shown in the illustration is for example purposes only.(7) Additional equipment and cables shown are not supplied with this set.(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifiedfrequency range.(9) Component Input is possible with the pin 1, 2, 3 of the D-sub 15P Connector.167839451015 14 13 12 112Signal Names for D-sub 15P ConnectorPin Layout for PC InputTerminalPin No.12345Pin No.678910Pin No.1112131415Signal NameR (P R/CR )G (Y)B (P B /CB )NCGND (Ground)Signal NameGND (Ground)GND (Ground)GND (Ground)NC (not connected)GND (Ground)Signal NameNC (not connected)NCHD/SYNCVDNC