Panasonic TH-42PV500A Operating Instructions Manual

Also see for TH-42PV500A: Service manual

17TuningMENUPress the MENU button.Move to choose Setup menu.Access Setup menu.Move to choose Tuning menu.Access Tuning menu.Move to choose Manual tuning.Access Manual tuning.Select the programme position to be tuned.Press repeatedly until required station is found.When the desired station is found, press the OK button to store.The programme position will flash.Press the EXIT button at any time to go back to watching TV.TV1 2 34 5 67 8 90OKEXITOKSTR F TV/AVManual tuningSearch down/upStoreProgramme down/upReturnExit1STR F - / + / TV / AV5. 5MHzManual tuning (Front panel)15. 5MHz- , + : SearchTV / AV : Move cursorSTR : To storeF : To exitIt is possible to retune individual programme positions:Manual tuningManual tuning (via front panel)Press the F button until Tuning mode is reached.Press the –/ or +/ button to access Tuning mode.Press the F button until Manual tuning is reached.Press the –/ or +/ button to access Manual tuning.Press the TV/AV button to move between Changeprogramme, Search and Change sound system.Press the –/ or +/ button to change programme positionor start search.When the desired station is found, press the STR buttonto store.The programme position will flash.Repeat above procedure to tune additional programmepositions.Press the F button at any time to exit the Tuning menu.It is also possible to use the control panel buttons on the front of the TV to tune individual programme positions:Notes:• If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the Colour systemselection on page 15.• After the Manual tuning is finished, press the Programme Number up button to confirm the tuning condition for eachProgramme Numbers. If some Programme Numbers are unused, it is possible to skip such Programme Numbers.Please refer to the Skip function on page 15.• When using a VCR without video and audio input / output terminals, it is convenient to connect the aerial cableas indicated in the instruction manual of VCR and to set the designated channel to Programme No.“0”. In thatcase, perform Manual tuning after setting the Colour system and Sound system in advance. Further, in multi-system VCR, it is more convenient to set the designated channel to several Programme Numbers.