Panasonic TH-42PV500A Operating Instructions Manual

Also see for TH-42PV500A: Service manual

ANT INPUTANT OUTPUT8Antenna connectionMixerVHF AerialVCR75 Ω Coaxial cableORConnect the mains plug to the wall socket.Press the [ ] switch on the TV set to turn the seton.Owner ID setting screen is displayed. See page 22.To switch the TV set to Standby mode, press thebutton on the remote control.The TV set can be switched on by pressing thebutton again if it was in Standby mode.Note:This TV will still consume some power as long as themains plug is still inserted into the wall socket. TV1 2 34 5 67 8 90OKPower On / OffFor proper reception of VHF / UHF channels, an external antenna is required. For best reception, an outdoor antennais recommended.UHF AerialNotes:• Do not put the Coaxial cable close to the mains lead to avoid noise.• Do not place the Coaxial cable under the TV.• Additional equipment, cables and adapter plugs shown are not supplied with this TV set.• To obtain optimum quality picture and sound, an Aerial, the correct cable (75 Ω coaxial) and the correct terminatingplug are required.• If a communal Aerial system is used, you may require the correct connection cable and plug between the wall Aerialsocket and your TV.• Your local Television Service Centre or Dealer may be able to assist you in obtaining the correct Aerial system foryour particular area and the accessories required.• Any matters regarding Aerial installation, upgrading of existing systems or accessories required, and the costsincurred, are the responsibility of you, the Customer.Remote control signal sensorPower IndicatorStandby : RedOn : No LightC.A.T.S. sensorPlasma C.A.T.S. (Contrast Automatic Tracking System)automatically senses the ambient light conditions and adjusts thebrightness and gradation accordingly, to optimize contrast.C.A.T.S. is in effect when Menu in Picture menu is set to Auto.See page 19.