Basic operations24 ENGLISHProject an imagePreparationsConfirm the connections of the peripheral devices•( page 18, 19) and power cord ( page 20).Switch on the power• ( page 22) to start projecting.Select the input signal and adjust the image.•SELECT THE INPUT SIGNAL1 Switch on the connected devices.When playing a connected DVD player, if SIGNALSEARCH (DISPLAY OPTION menu) is set toON, the input signal is detected and projectedautomatically when the projector is switched on.( page 37)Set the• INPUT GUIDE (DISPLAY OPTION ON-SCREEN DISPLAY menu) to DETAILED. Ifthe projector cannot detect any input signal, the“Computer connection guide” will be displayed.( page 35)2 Select an input signal.The image selected with any of the [INPUTSELECT] button is projected.NOTE:Change the settings in the• PICTURE menu according to theconnected device for example DVD, video tape, etc., to beplayed. ( page 30)Confirm the aspect ratio of the screen and image.•Select the optimum aspect ratio. ( page 33)POSITION THE IMAGEWhen setting up the projector for the first time orsetting up at a new place, you must perform thefollowing operations.1 Adjust the vertical angle of the projector.Place the projector at the right angle from the•screen.Press the leg adjuster button• and adjustthe vertical projection angle. Then, adjust theprojected image to the center of the screen.2 Adjust the projection size and focus.Turn the zoom and focus rings to adjust the•projected image.NOTE:When you adjust the zoom after adjusting the focus, you•may need to adjust the focus of the image again.If the projected image slants to the right or left, turn the rear•leg adjuster to adjust the angle of the projector.If keystone distortion occurs, see KEYSTONE.•( page 32)Zoom ring(ZOOM)Focus ring(FOCUS)Rear leg adjuster