SettingsENGLISH 39Menu operation (continued)▌NO SIGNAL SHUT-OFFIf no image signal is input for the time set using thetimer, the projector will automatically enter into standbymode.Change settingChangesettingChangesettingChange settingDISABLE NO SIGNAL SHUT-OFF is disabled15 – 60MIN.Timer can be set at a 5-minute intervals▌INITIAL START UPYou can set the starting method when the power plug isconnected to wall outlet.Change settingChangesettingChangesettingChange settingLASTMEMORYProjector starts from the last imagebefore the power plug was disconnectedSTANDBY Projector starts in the standby modeON Projector starts immediately▌INSTALLATIONWhen installing the projector, select the projectionmethod according to the projector’s position.( page 17)Change settingChangesettingChangesettingChange setting▌HIGH ALTITUDE MODEIf you use the projector at high elevation, the HIGHALTITUDE MODE setting need to be ON to set the fanspeed to high.Change settingChangesettingChangesettingChange settingOFFUse in normal environment(below 1 400 m (4 593 ft) above sealevel)ONUse at high altitude(at 1 400 m – 2 700 m (4 593 - 8 858 ft)above sea level)NOTE:The loudness of fan noise depends on the• HIGHALTITUDE MODE setting.▌STANDBY MODEYou can change the standby mode setting.Change settingChangesettingChangesettingChange settingECO The standby power is reduced to 0.4 Wto save powerNORMALThe power of the projector can beturned ON and the audio output can beset active by controlling the computerconnected via wired LAN in standbymode▌LAMP POWERYou can adjust the power of the lamp to save electricity,prolong the lamp life and reduce the noise.Change settingChangesettingChangesettingChange settingNORMAL When higher luminance is requiredECO When lower luminance is sufficientNOTE:This function is disabled when no input signal is detected.•ECO• setting is recommended when higher luminance is notrequired such as in a small room.