Panasonic Viera TH-P42ST30A Operating Instructions Manual

Also see for Viera TH-P42ST30A: Service manual

Auto Tuning15Setup the network connectionSet up the network connection to enable the network service functions such as VIERA Connect, etc.(p. 17, 78).• To set up the wireless connection, the Wireless LAN Adaptor (optional accessory) is required.• Please note that this TV does not support wireless public access points.• Ensure the network connections and network environment are completed before starting setup.1 Connect the LAN cable or Wireless LAN AdaptorTo enable the network service functions (VIERA Connect, etc.), you need to connect the TV to abroadband network environment.InternetenvironmentInternetenvironmentWired connectionWireless connectionAccess pointLAN cable• Use the Shielded Twist Pair (STP) LAN cable.Wireless LAN Adaptor“Optional accessories” (p. 9)• Connect to theUSB 1, 2 or 3 port.orRear of the TV• If you do not have any broadband network services, please consult your retailer for assistance.• For more information of the network connections (p. 70)Caution• To use the Wireless LAN Adaptor, an Access Point needs to be obtained.• It is recommended to use the Wireless LAN Adaptor with the extension cable.• To avoid radio wave interference, keep the TV away from the devices such as other wirelessLAN devices, microwaves and the devices that use 2.4 GHz and 5 GHz signals when using theWireless LAN Adaptor.Otherwise malfunction may occur.2 Select [Wired] or [Wireless]Network SetupSelect Wired or WirelessWired Wireless Set later accessselect3 Start the settings■ [Wired]Select [Auto]Acquire IP AddressAuto Manualaccessselect• To set manually, select [Manual] and seteach item. For details (p. 72 - 73)Check network cable connection.Check acquired IP address.Check for devices using same IP address.Check gateway connection.Check server connection.Connection TestAutomatically setup is done and the test of thenetwork connection starts.: succeededThe test is successful and the TV isconnected to the network.: failedCheck the settings and connections, andthen select [Retry]