Panasonic Viera TX-L32E3E Operating Instructions Manual

Also see for Viera TX-L32E3E: Service manual

Contents

Auto SetupQuick Start Guide12Auto SetupSearch and store TV channels automatically.tThese steps are not necessary if the setup has been completed by your local dealer.tPlease complete connections (p. 10, 11) and settings (if necessary) of the connected equipment before starting Auto Setup.For details of settings for the connected equipment, read the manual of the equipment.TV1 Plug the TV into mains socket and switch OntTakes a few seconds to be displayedtIf the red LED shows on the TV, press the Standby On / Off switch onthe remote control for about 1 second.2 Select the languageMenüspracheDeutsch Dansk Polski SrpskiEnglish Svenska čeština HrvatskiFrançais Norsk Magyar SlovenščinaItaliano Suomi Slovenčina LatviešuEspañol Türkçe Български eesti keelPortuguês Еλληνικά Română LietuviųNederlandsselectset3 Select your countryCountryGermany Denmark PolandAustria Sweden CzechFrance Norway HungaryItaly Finland SlovakiaSpain Luxembourg SloveniaPortugal BelgiumEstoniaSwitzerland NetherlandsLithuaniaMalta TurkeyOthersAndorra GreeceCroatiaselectsettDepending on the country you select,select your Region or store the Child Lock-PIN number (“0000” cannot be stored) byfollowing the on screen instructions.4 Select the mode you want to tuneDATV Signal SelectionDVB-CDVB-TAnalogueStart Auto Setuptune / skip tuningselect: tune (search for the available channels): skip tuning5 Select [Start Auto Setup]DATV Signal SelectionDVB-CDVB-TAnalogueStart Auto SetupaccessselecttAuto Setup will start to search for TV channels and store them.The stored channels and sorted channel order vary depending on the country, area,broadcasting system and conditions of signal reception.Auto Setup screen varies depending on the country you select.1 [DVB-C Network Settings]tDepending on the country you select, select your cable provider beforehand byfollowing the on screen instructions.DVB-C Network SettingsFrequency AutoNetwork IDStart Auto SetupAuto accessselect[Start Auto Setup] jklghi mnotuvpqrs wxyzabc defNormally set [Frequency] and [Network ID] to [Auto].If [Auto] is not displayed or if necessary, enter [Frequency] and [Network ID] specified byyour cable provider with numeric buttons.