72The described below let you determine the system desig-nation and display the system logs.1. Move the cursor to SYSTEM SETUP in the WJ-HD500SETUP menu by pressing the C or D button, thenpress the SET button.The SYSTEM SETUP menu shown below appears onthe monitor screen.2. Select an item or item parameter in the menu by press-ing the D or C button.3. To return to the previous setup menu, press theSETUP/ESC button.■ Clock SetupThis item lets you set the current time and date.1. Move the cursor to CLOCK in the SYSTEM SETUPmenu by pressing the C or D button, then press theSET button to move the cursor to the right editing area.2. Select the month by pressing the + or - button.3. Move the cursor to the right by pressing the B button,then select the date by pressing the + or - button.4. Move the cursor to the right by pressing the B button,then select the last 2 digits for the year by pressing the+ or - button.5. Move the cursor to the right by pressing the B button,then select the hours (military time) by pressing the +or - button.6. Move the cursor to the right by pressing the B button,then select the minutes by pressing the + or - button.9 SYSTEM SETUPCLOCK JAN 1.00 0:00TIME ADJUSTING OFFSET TIME 0:00AUTO KEY LOCK OFFPASSWORD ALL *****OPERATION *****BUZZER ONUSER DEFINED SETUP *LOADDISK MANAGEMENTERROR REPORTSYSTEM INFORMATIONSYSTEM SETUP7. After completing the setting, press the SETUP/ESCbutton to move the cursor to CLOCK.Note: The date and time are updated when the SETUP/ESC button is pressed.■ Time Adjustment SettingThis Disk Recorder has a time adjustment input/output atthe CONTROL port on the rear of the Disk Recorder.This item lets you enable or disable time adjustment by theinput/output from the CONTROL port.1. Move the cursor to the TIME ADJUSTING parameter inthe SYSTEM SETUP menu by pressing the C or D but-ton.2. Select the desired mode by pressing the + or - but-ton.OFF: Disables the time adjustment from the CONTROLport.MASTER: Enables the time adjustment output from theCONTROL port to set the time for connected exter-nal device.SLAVE: Enables to set the time of this recorder by theinput from the CONTROL port.The factory default setting is OFF.3. If the parameter is set to something other than OFF,move the cursor to SET TIME by pressing the C or Dbutton, then press the SET button.The cursor moves to the right editing area.4. Select the hour (military time) to execute the timeadjustment by pressing the + or - button.5. Press the SETUP/ESC button to return the cursor toSET TIME.
