Panasonic WJ-ND400K Setup Instructions

Also see for WJ-ND400K: Operating instructions Manual Specification Specification sheet Quick reference guide

Contents

Panasonic WJ-ND400K Setup Instructions Manual pdf 34 page image

34Emergency recordingSets the recording duration or recording rate when performing emergency recording by input of the emergency recording input signal. For detailsabout emergency recording, refer to the Installation Guide.1 Click the [Emergency rec.] button on the setup menu.This will display the "Emergency rec." window.Button Functions2 Configure the settings for each item.Refer to “Emergency recording settings” table for detailsabout the settings.• To configure the settings of a camera that is not shown onthe display, click the applicable camera number rangeabove the [Set] button to change the contents of thedisplay.• Clicking a camera number range will save the currentlydisplayed camera settings.3 Click the [Set] button.Emergency recording settingsEmergency recording[Measurement]button: Click to check for proper operation atthe specified recording rate. (page 36)Important:• Recording may not be possible for about four seconds immediately after emergency recording is complete.Item Settings DescriptionRecording duration 2s / 5s / 10s♦ / 20s / 30s / 1min /3min / 5min / 10min / 30min /Manual / ContinueSpecifies the duration of emergency recording.• Selecting [Manual] records while the emergency recordinginput signal is being input. Also, recording is performed for aminimum of 8 seconds.• Selecting [Continue] causes recording to continue until the"Alarm [ALM]" button is clicked.Model Shows the registered model numbers of the cameras.Compression Shows the image compression format for registered cameraimages.• Refer to "Checking and changing a camera (Manuallysetting) (page 50)" for details about compression methodsettings.MeasurementMax. network speed (Mbps) Shows the maximum bit rate on the network being used whenthe [Measurement] button is clicked.Max. bit rate (ips) Shows the maximum recording rate on the network being usedwhen the [Measurement] button is clicked.• A red rate setting value indicates that live images orrecording of the image may not be possible at the specifiedrate.Recorder setupRecording rate Off♦ / 1ips / 2ips / 3ips / 5ips /10ips / 15ips / All /I-FrameSpecifies the rate of emergency recording.• Available settings differ according to the compression formatof the camera. Refer to "Checking and changing a camera(Manually setting) (page 50)" for details about compressionmethod settings.