Panasonic WJ-ND400K Setup Instructions

Also see for WJ-ND400K: Operating instructions Manual Specification Specification sheet Quick reference guide

Contents

Panasonic WJ-ND400K Setup Instructions Manual pdf 72 page image

User management72The following procedure is to register information for PCs (hosts) that can access the camera over a network.Up to 32 hosts can be registered.1 Click the [User mng.] button on the setup menu.2 On the sub-menu that appears, click [Host].This will display the "Host setting" window.3 Configure the settings for each item.Refer to “Host settings” table for details about the settings.4 Click the [Set] button.Host settings♦Initial defaultNote:• Clicking the [Registration] button does not log out other users.HostsItem Settings DescriptionHost IP address Address input (Blank♦) Enter the IP address.• Enter single-byte numerals in the range of 0 to 255.• You can use the "*" special character to represent anynumber.• "0.0.0.0" or "*.*.*.*" cannot be registered.Level LV1♦ / LV2 / LV3 / LV4 Specifies the user level.• For operations that can be performed at each level, refer to"User level (page 74)".Access priority 1♦ to 16 Specifies the priority sequence for operations when multipleusers are logged in on the recorder at the same time.Default screen [Cam.1]♦ to [Cam.64] / [Cam.1-4]/ [Cam.5-8] / to / [Cam.61-64] /[Seq]Specifies the live image display immediately after log in.• Selecting [Cam.1] to [Cam.64] displays the images of theselected cameras on a 1-image screen.• Selecting [Cam.1-4] to [Cam.61-64] displays the live imagesof the selected cameras on a 4-image screen.• Selecting [Seq] displays images in a specified sequence.Camera partitioning [View/Operate]♦ / [View] / [--] Specifies the scope of control for each camera channel.• When [View/Operate] is selected, live/recorded imagedisplay or camera operation can be performed.• When [View] is selected, live/recorded image display can beperformed, but camera operation cannot.• When [--] is selected, neither live/recorded image display norcamera operation can be performed.Important:• You must click press the [Set] button to activate settings on the recorder when registering, editing, or deleting hosts.