13Configure the Network SettingsWith the following network environment, it is not necessary to configure the network settings. It is possible to config-ure the settings or operate the recorder using the monitoring software after completing the connection.IP Address: 192.168.0.2 - 192.168.0.249, 192.168.0.251 - 192.168.0.254Subnet Mask: 255.255.255.0Gateway Address: 192.168.0.1When the network settings are different from the settings above, configure the network settings of the recorder andthe PC.Configure the network settings of the recorderUse the buttons on the front panel of the recorder to conform the network settings to the network environment of thePC.Refer to the installation guide of the recorder for further information about the network settings (The "Configure thenetwork settings [Network Setup]" section under the "Configure the settings relating to communication with otherdevices [Communication Setup]" chapter in the descriptions of "Setup Menu").Configure the network settings of a PCChange the TCP/IP setting of the PC to conform to the settings of the recorder.It is required to set the IP address of the PC to "192.168.0.XX (a number from 2 to 254 except 250)" to access therecorder.Screenshot 1Start just after the PC is started up.Important:Log in to the PC as an administrator.Step 1On the taskbar, click "Start", and then click the "ControlPanel".
