35TIME-LAPSE VCR CONTROL [NON-PANASONIC MODELS] (TERMINAL MODE)MUXMONITOR DISPLAY CONTROL (PS·DATA)A time-lapse VCR is operable with the system controller,while connecting to the matrix switcher.Notes:• Before the use, it is necessary to install theMultiplexer board in the matrix switcher, connectthe matrix switcher to the digital disk recorder, andconfigure the system through WJ-SX150AAdministrator Console, OSD SETUP MENU, andtime-lapse VCR's SETUP MENU. (Refer to the oper-ating instructions of matrix switcher.)• You cannot control non-Panasonic time-lapse VCRsfrom system controllers.The following is the procedure of a non-Panasonic modeltime-lapse VCR.■ Controlling the Time-lapse VCR● Multiscreen Segment SwitchingThe operations are the same as WJ-HD500 Series.(Refer to p. 19.)Note: 7-, 10-, and 13- segment multiscreen display pat-terns are unavailable.● Normal Playback1. Enter the recorder mode. (Refer to p. 19 RecorderMode.)2. Do the playback procedure using the buttons on thefront panel. (Refer to the time-lapse VCR’s operatinginstructions for how to operate.)3. Press the PLAY/PAUSE button. The playback image willappear on the monitor.4. To display the spot picture, press the numeric buttonscorresponding to the desired camera number, thenpress the CAM (SET) button. Then, the active monitornumber will appear on the LCD. (Refer to p. 20 NormalPlayback for the illustration.)● Other OperationsRefer to the time-lapse VCR’s operating instructions for howto operate.The operations are the same as System Controller WV-CU360C/CJ.(Refer to the operating instructions of matrix switcher forhow to operate.)However, the following operations differ from SystemController WV-CU360C/CJ.■ On-screen Display (OSD)ControlRefer to WV-CU950/650 Operating Instructions.■ Video Loss History TableRefer to WV-CU950/650 Operating Instructions.