Panasonic WJ-SX150 Series Addendum

Also see for WVCU650 - SYSTEM CONTROLLER ADDENDUM: Product catalog Specifications Operating instructions Operating instructions

Contents

Panasonic WJ-SX150 Series Addendum Manual pdf 4 page image

4Note: This section describes the terminal mode. To operatein the PS·Data mode, refer to the operating instructions.Buttons and control for cameras or camera site accessoriesare located on the 3D joystick unit and the right side ofmain unit.Included are zoom control, focus control, iris control, presetand pan/tilt controls.Normally, combination cameras equipped with the specificfeature or a WV-RC100 or WV-RC150 Receiver are requiredto utilize these functions.Note: Refer to the cameras' operating instructions whetherto confirm that each function is available.■ Lens ControlThis function is available when specified lens, with motor-ized zoom/focus functions, is mounted on the camera, andthe lens selection (DC/VIDEO) on the camera is set to DC.1. Select the desired monitor and camera. (Refer to p. 3Monitor Selection and p. 3 Camera Selection.)2. Press the FOCUS FAR or NEAR button while watchingthe monitor. The lens focus is adjusted to obtain asharply focused image.Note: Pressing the B button or top button of 3D joystickunit can also set the lens focus automatically.3. To adjust the lens zoom, move the zoom wheel con-troller to the right (TELE) or left (WIDE).4. Press the IRIS OPEN or CLOSE buttons to open/closethe lens iris. The lens iris is adjusted by these buttons toobtain the proper image exposure.Note: To set the lens iris automatically, press the A but-ton of 3D joystick unit.■ Pan/Tilt Control● Manual Operation1. Select the desired monitor and camera. (Refer to p. 3Monitor Selection and p. 3 Camera Selection.)2. Move the 3D joystick to move the pan/tilt head towardsthe desired direction.● Auto PanningRefer to p. 8 Camera Panning Function for how to oper-ate.CAMERA CONTROLFARFOCUSNEAROPENIRISCLOSETop buttonWIDE TELEZoom wheel controller