111FEATURES Log-inTo operate the Matrix Switcher System 500, a registeredoperator must first supply his/her Operator Number andPassword to the system.The operator number and password are established byusing the REGISTRATION table. See page 16 for moredetails on operator number registration.If an attempt is made to enter an operator number andpassword that do not match with the registered operatornumbers and passwords, entry into this system is denied.As shown in the examples below, there are 2 additionalattributes associated with an operator: operator level andpriority. These items are described in more detail on page16.Operator name: MikeOperator Number: 1Operator Level: 1Password: 07171Priority: 1Operator name: RobertOperator Number: 15Operator Level: 13Password: 11524Priority: 8Notes:• Factory Default Setting Operator Number: 1Password: 12345are registered to allow access for first time systemprogramming.• An operator can be logged-in to this system fromseveral system controllers.• If the main power of the Matrix Switcher is turnedoff, log-in procedures must be performed again.• If power to the system controller is turned off, thesystem controller will record operating status whenpower is resupplied. Camera and Monitor SelectionAfter logging in, the desired camera and monitor combina-tion can be selected.Basically, any combination of camera and monitor, whichare connected to the Switcher, can be selected as shownbelow.General Procedures1. Select the desired monitor. (Monitor and controllerare linked.)2. Select the desired camera. (Camera and controllerare linked.)3. The picture of the selected camera view is dis-played on the selected monitor. Monitor SelectionBy selecting the monitor with the System Controller, it islinked with the System Controller.At this time, the camera output signal that was last suppliedto the monitor is displayed.Press the Numeric keys (1 to 16), then press the MON(ESC) key to select the desired monitor.For example: When selecting monitor Number 5:Press 5, then press the MON (ESC) key.123Camera-1 Camera-2WV-RC150ControllerMonitor-1 Monitor-2WJ-SX550CSystem Controller WV-CU 550 BCAMESC SET1 2 34 5 67 8 9MON 0

operating instructions

monitor selection

camera selection

tour sequence

group sequence

alarm recall

operator registration

system status display

cpu board

front view

connection with the camera sites

connection with the system controllers

setup menu

level table

camera title

system menu

controlling camera site accessories

patrol learn and play

camera setup

alarm operation

priority lock

Panasonic WJ-SX550C Operating Instructions Manual

WVCU550C - SYSTEM CONTROLLER UNIT

system controller

IMPORTANT SAFETY INSTRUCTIONS

PREFACE

PRECAUTIONS

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS

INSTALLATION

SYSTEM INFORMATION

SPECIFICATIONS

WJSX550C - MATRIX SWITCHER