1195Note: “AL0” or “AL1” is displayed in the upper rightcorner of the alarmed monitor. To Cancel Alarm (Plural Monitors)The following function is used to cancel alarm in a lumpwhen Alarm Mode 1 or 2 is activated.1. Select the alarmed monitor.Select Monitor 1 if Alarm Mode 1 is activated, or one ofMonitors 1 - 4 if Alarm Mode 2 is activated.2. Press the ALT button. The LED indicator on the buttonlights.3. Press the ACK RESET button once for alarm acknowl-edgment.The LED indicator on the button blinks rapidly.4. Press the ACK RESET button once again for alarmreset.The LED indicator on the button goes off.Note: Select one of the monitors, that is running theGroup Sequence by activating the Alarm Mode 3,then follow the steps above to cancel the alarmedmonitors at once. Alarm Control Alarm Input SelectionThe following settings enable or disable alarm inputs fromthe camera site or Alarm Board after the Alarm Mode Selectitem has been set in the Setup Menu.1. Select the Alarm in (A5) Menu on the LCD display bypressing the appropriate Direction button.2. Press the Function (F1) button to toggle the CameraSite Alarm on and off.3. Press the Function (F2) button to toggle the InterfaceAlarm (Alarm Board) on and off. Alarm OperationWhen an alarm is activated, the ALARM indicator on thecontroller blinks.The indicator keeps blinking until all alarms are cleared bypressing the ACK RESET button. To Cancel Alarm (Single Monitor)1. The alarmed monitor(s) must first be selected.Refer to the Monitor Selection.2. Press the ACK RESET button once for alarm acknowl-edgment.The LED indicator on the button blinks rapidly.3. Press the ACK RESET button once again for alarmreset.The ALARM indicator goes off, and the LED indicatoron the button goes off.ALARM LEDACKRESET ACKRESETF1 F2Alarm inSite BoardA5On: Site BoardOff: Site BoardMAY 07'00 14:23:56 ALOC 01 M16 3rd FloorRoom 306ACKRESET ACKRESETALT