Setup29• Select English, German, French, Spanish or Italian asthe language which is to appear on the LCD panel.• English is the default language.1 Press MENU/EXIT (PAUSE) button to enter theMenu mode.2 Press (CONTINUE) or (CANCEL) button untilthe Other menu appears.3 Press ENTER button.Language item menu appears.4 Press ENTER button.English selection menu appears.5 Press (CONTINUE) or (CANCEL) button untilthe desired language is displayed.6 Press ENTER button to activate your selection.NOTE:• Adhere the enclosed ìSupplies Re-order Labelî near theprinterís LCD panel to assist you in interpreting thesupplies related messages that may appear on theprinterís LCD display.It is possible to confirm the printer's settings by printing aconfiguration page.1 Press MENU/EXIT (PAUSE) button to enter theMenu mode.2 Press (CONTINUE) button until Test Page menuappears.3 Press ENTER button.Menu Map item menu appears.4 Press (CONTINUE) button until ConfigurationPage item menu appears.5 Press ENTER button.The printer will start printing a configuration page.The printer panel provides an interface to adjust thedensity of the toner applied to the media.This feature compensates for the changes that can occuras environmental conditions change, replacement ofaccumulator unit and/or print cartridge.Perform the following steps to adjust the color density:1. Print a Color Calibration Test Print Page to confirm thecurrent density (Color Calibration) and compare it withthe provided Color Calibration Card.2. If you wish to adjust the density for all colorssimultaneously, proceed to ìAdjusting the Densityfor All Colors Simultaneouslyî.ORIf you wish to adjust the density for each colorindependently, proceed to ìAdjusting the Density forEach Color Independentlyî.1 Press MENU/EXIT (PAUSE) button on the printerpanel.2 Press (CONTINUE) button until Color Calibrationmenu is displayed.3 Press ENTER button.Calibration Offset item menu appears.4 Press (CONTINUE) button until Calib. Test Prn.menu is displayed.5 Press ENTER button.A Color Calibration Test Print Page will be printed.• The current density setting for each color isindicated by the line enclosure on the ColorCalibration Test Print Page as shown in thefollowing example.Setting the LCD LanguagePrinting a Test Page fromthe Printer PanelAdjusting the Color Density(Color Calibration)Printing a Color Calibration Test PrintPageSetup