Panasonic WV-BPR550 Operating Instructions Manual

Also see for WVBPR550 - CCTV: Specifications Operating instructions

Notes:• When the “I" cursor reaches the 'V' end, itjumps back to At the same time. COARSEis incremented by one step to enable a contin¬uous adjustment. The reverse takes placewhen the “I" cursor reaches the end.• When Cl or © is kept pressed for a secondor longer, the “I" cursor moves faster.• To reset COARSE and FINE to the values pre¬set at the factory, press Cl or G3> simultane¬ously. COARSE and FINE adjustments arepreset at the factory to zero-crossing of theAC line phase.• If the AC line contains noise {spike noise,etc.), the stability of the vertical phase of thecamera video output signal may be disturbed.7. Motion Detector Setting (MOTION DET)The motion detector detects the moving objects in thescene by monitoring the brightness level changes. Youcan select the level of sensitivity for motion detection.When this camera is connected to a compatible intelli¬gent CCTV system, the camera transmits an alarm sig¬nal by multiplexing it with the video signal.1. Move the cursor to the MOTION DET parameterand select ON.2. Press £3. The MOTION DETECT menu appearson the monitor screen.** CAM SET OP •*CAMERA ID OFF “IALC/ELC ALC ~lSHCTTER —AQC ONSENS OP OFFSYNC I NTMOTION DET ON | "%DENS DRIVE DC** MOTION DETECT ••LEVEL _I . . .DISPLAY MODEALARM ONMASK SET "%RET END3. Move the cursor to MASK SET and press GO. TheMASK SET menu has 48 masks. To set MASK SET,proceed as described in steps 2 to 4 of “ALCmode with SUPER-D OFF and ELC mode” on page26.4. Move the cursor to the ALARM parameter andselect ON or OFF to set the alarm in the DISPLAYMODE.Note: When the system controller WV-RM70, WV-CU550 or WV-CU55QA is used with thismodel, select OFF for ALARM.5. Move the cursor to DISPLAY MODE and press £3to see the current setting. The masks that detectthe brightness changes start blinking.-32-