Panasonic WV-BPR550 Operating Instructions Manual

Also see for WVBPR550 - CCTV: Specifications Operating instructions

9. Special Menu (SPECIAL)This menu lets you adjust and setup the video signal ofthe camera to meet your requirements.Move the cursor to RET on the bottom line of the CAMSET UP menu and press €] or simultaneously for2 seconds or longer. The SPECIAL menu appears onthe monitor as shown below.(- T /-\*• CAM 1BET UP •• * * SPECIAL ••CAMERA ID OFFALC/ELC ALC UP SIDE DOWN OFFSHUTTER — AP GAIN _I_AGC ON k PEDESTAL .1.SENS UP OFF m “ +SYNC INT fMOTION DET OFFLENS DRIVE DC CAMERA RESET -» PUSH SWRKTj ' RET ENDV___ J k_/9-2. Aperture Gain Setting (AP GAIN)1. Move the cursor to the AP GAIN parameter.2. While observing the vector scope or video monitor,move the "I" cursor to adjust the aperture gainlevel.9-3. Pedestal Level Setting (PEDESTAL)1. Move the cursor to the PEDESTAL parameter.2. While observing the wave form monitor/oscillo¬scope or video monitor, move the T cursor toadjust the pedestal level (black level).To reset to the factory settings1. Move the cursor to the CAMERA RESET parame¬ter. The words PUSH SW start blinking.2. While holding down €] and 13, press [£J for 2seconds or longer. The camera is reset to the fac¬tory settings.9-1. Camera Picture Upside Down Positioning(UP SIDE DOWN)1. Move the cursor to the UP SIDE DOWN parameter.2. Select ON when you want to turn the pictureupside down.To close the SPECIAL menu and return to the CAMSET UP menuMove the cursor to RET and press HD .To close the SPECIAL menu and return to the cam¬era pictureMove the cursor to END and press HD.-34-