Panasonic WV-BPR550 Operating Instructions Manual

Also see for WVBPR550 - CCTV: Specifications Operating instructions

6. To raise detection sensitivity, press GO to return tothe MOTION DETECT menu.7. To obtain the optimum detection level, move theT cursor to adjust the level.8. Repeat the procedures above to obtain a satisfac¬tory setting.9. Move the cursor to RET and press GO to return tothe CAM SET UP menu.Notes:• Masking or adjusting the detection level is neededto prevent malfunction under the following condi¬tions:• When shooting an object under flickering fluores¬cent light or shooting in ELC.• When leaves or curtains etc. are swayed by thewind.• When the object is lighted by lighting equipmentthat constantly turns on and off.• It takes about 0.2 seconds for the alarm signal toreach the alarm terminal of the VCR after the cam¬era detects the object.Because the alarm signal is multiplexed on thevideo signal, it may be mistakenly interpreted byother video equipment as a time code signal.Therefore, when camera is not used in aPanasonic Intelligent CCTV System select OFF toprevent the above from occurring.8. Lens Drive Signal Selection(LENS DRIVE)This item is used to select the type of auto iris lensdrive signal to be supplied to the lens from the auto irislens connector.-** CAM SET DP **CAMERA ID OFF IALC/ELC ALCSHUTTER —AGO ONSENS DP OFFSYNC INTMOTION DET OFFLENS DRIVE :DC;iRET_1. Move the cursor to the LENS DRIVE parameter.2. Select DC if you are using the auto iris lens thatrequires a DC drive signal.Select VIDEO if you are using the auto iris lens thatrequires a video drive signal.-33-