14SETTING PROCEDURESThe following setting procedures are described on the assumption that this model is used in combinationwith the WJ-SX550B matrix switcher and WV-CU550B system controller. In case of using other controllerthan the WV-CU550B, refer to the table on page 8. Menu Display Setup Menu DisplayWV-CU550B1. Select the number of the camera you want to set up and a monitorto display the SET UP MENU.2. Display the D4 menu on the LCD by pressing the appropriate cur-sor buttons.3. Press the F1 button.The SET UP MENU appears on the monitor.4. To close the SET UP MENU, press the F4 button.WV-CU360Press the CAM SETUP key for 2 seconds or more to open theSETUP menu.WV-CU151Press the CAM MENU switch for 2 seconds or more to open theSETUP menu.WV-RM701. Turn the MODE SELECTION switch to the NORMAL or ALARMOFF position.2. Press the PROG switch for 2 seconds or more to open theProgram menu.3. Move the cursor to Camera Set Up, then press the SET switch toopen the SETUP menu.D4 menuF1F1 F2 F3 F4Camera Set Up MenuRes A.Res ExitF2 F3 F4Camera Set Up MenuOn Exit** RS485 SET UP **UNIT NUMBERSUB ADDRESSBAUD RATEDATA BITPARITY CHECKSTOP BITXON/XOFFWAIT TIMEALARM DATADELAY TIMERET11192008NONE1NOT USEOFFAUTO2OFFSubmenu(for RS485 setup)*** SET UP MENU ***PRESET 1*MAPHOME POSITIONSELF RETURNAUTO MODEAUTO PAN KEYDIGITAL FLIPLOCAL/REMOTESPECIAL1CAMERARS485 SET UP1510MINOFFAUTO PANOFFLOCALSetup menu*** SET UP MENU ***PRESET 1*MAPHOME POSITIONSELF RETURNAUTO MODEAUTO PAN KEYLOCAL/REMOTEPATROLCLEANINGCAMERA810MINOFFAUTO PANLOCALSTOPOFFSetup menu Submenu DisplayThe items marked can be selected/changed on the submenu.• Move the cursor to an item with the mark and press the CAM(SET) key. The submenu is displayed.