Panasonic WV-CS570/G Operating Instructions Manual

Contents

Panasonic WV-CS570/G Operating Instructions Manual Manual pdf 13 page image

-13-1 2 3 4ON5 6 7 8DIP Switch 1 UnitNumber1 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 8DIP Switch 1 UnitNumber DIP Switch 1 UnitNumber6970717273747576777879808182838485868788899091929394951 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 8* When using the Unit Number 1 to 96 setting, the unit number setting needs to be configured using the RS485 SETUP menu. For details about configuring this setting, see step 2 and page 19.* Turning on power when this setting is selected causes the RS485 SET UP menu to appear during the initializationroutine. RS485 Communication Parameters (DIP Switch 1)Configuring DIP Switch 1 as shown below resets communication parameters to their factory default settings. You canthen change the settings as desired.Perform the following steps to use this setting.(1) Turn off the camera and use DIP Switch 1 to configure RS485 communication parameters as shown above.(2) Turn on the camera.This applies the setting you configured in step (1).(3) Turn off the camera, use DIP Switch 1 to set the unit number (pages 12 and 13), and then turn the camera back onagain.1 2 3 4ON5 6 7 8DIP Switch 1 Setting Description1 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 8This setting resets communication parameters to the factory default settings.BAUD RATE : 19 200 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bitBAUD RATE : 9 600 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bitBAUD RATE : 4 800 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bitON