Panasonic WV-CU650 Operating Instructions Manual

Also see for WVCU650 - SYSTEM CONTROLLER ADDENDUM: Product catalog Specifications Addendum Operating instructions

Panasonic WV-CU650 Operating Instructions Manual Manual pdf 81 page image

3● Releasing Priority Lock1. Select the desired monitor. (Refer to Monitor Selection.)2. Press the MON LOCK/LOGOUT button to release thepriority lock mode.The monitor number returns to the normal display onthe active monitor.■ Camera Selection1. Select the desired monitor. (Refer to Monitor Selection.)2. Press the numeric buttons to select the desired cameranumber (1 to 99).3. Press the CAM (SET) button.The selected camera's image will appear on the activemonitor, and the selected camera number will appearon the LCD.Note: If you have entered a wrong camera number,press the CLEAR button to clear the input.4. If the selected camera number is not valid, "Prohibited"and the camera number will blink on the LCD for about3 seconds.In this case, return to Step 2 and select another cameranumber.5. To replace the currently selected camera with the nexthigher-numbered camera , press the + button.To replace the currently selected camera with the nextlower-numbered camera, press the – button.Note: If the camera is selected by an operator withhigher priority, "Prohibited" will blink on the LCD.Note: This section describes the terminal mode. To operatein the PS·Data mode, refer to the operating instructions.After the login procedure, the following operations are avail-able to control the system.The operation begins with selecting a monitor, then theselected camera appears the active monitor.■ Monitor Selection1. To select the desired monitor number (1 to 4), press thenumeric button.2. Press the MON (ESC) button to execute the selection.The selected monitor number will appear on the LCD.3. If the selected monitor number is not valid, or if an oper-ator with higher priority is controlling the monitor, themonitor number and "Prohibited" will blink on the LCDfor approximately 3 seconds.In this case, return to Step 1 and select another monitornumber.■ Priority Lock● Applying Priority Lock1. Select the desired monitor. (Refer to Monitor Selection).2. Press the MON LOCK/LOGOUT button to toggle the pri-ority lock mode on and off on the active monitor.If the priority lock mode is selected, the monitor numberwill inversely appear on the active monitor as shown inthe figure.Note: This function will prevent operators with lower priorityfrom gaining control of a monitor.However, higher or equal priority operators may stillgain control of the monitor.Mon1 Cam--MONITOR SELECTION AND CAMERA SELECTIONMon1 Cam03Mon1 Cam03Mon1 Cam04Mon- Cam--ProhibitedBlinkingM04