18Step 4Move the cursor to "AREA" and select the area for which the detection of appearance/disappearance of stationary objects is to beset.ALL (default): All areas will be set as the detection area.SETUP: When the setting button is pressed after selecting "SETUP", up to 2 areas can be set as the detection area. Refer to thedescription below for how to configure the settings.Step 5Move the cursor to "SENSITIVITY" and press the setting button.→ The "SENSITIVITY" screen appears.Step 6Move the cursor to "MIN SIZE" and select the minimum size of objects detected from the following: The size options will be displayedin a green frame in the center of the screen. In "OFF" position, any object will be detected regardless of its size.Perform the setup while viewing the detection result displayed on the screen.OFF (default)/SMALL/MEDIUM/LARGENote:• The detection areas set in step 4 will be displayed as a white frame on the "SENSITIVITY" screen.• When appearance/disappearance of a stationary object is detected, a red frame will be displayed on the "SENSITIVITY" screen.Set the detection areasSet the detection areas for motion detection and the detection of appearance/disappearance of stationary objects.Up to 2 detection areas can be set.Follow the procedure below.Step 1Move the cursor to "AREA" and select "SETUP", and then press the setting button.→ The "AREA" screen appears.Step 2Move the cursor onto the number to select the area number using the right or left button.Step 3Move the cursor to "POSITION" and press the setting button."OBJECT DET" screen Area setting screen"MOTION DET" screen**MOTION DET**(1)MOTION OFFLOITERING OFFDIRECTION OFFAREA SETUPSENSITIVITYRET TOP END**AREA 1 /2**(1)POSITION PUSH SWUPPER LEFTDELRET TOP END**OBJECT DET**(1)REMOVAL AND LEFT BEHINDDURATION TIME 10sAREA SETUPSENSITIVITYRET TOP END