115Reset the settings/Reboot the camera [Default reset]Click the [Default reset] tab of the "Maintenance" page. (☞ Pages 24 and 25: How to display/operate the setupmenu)The settings and the HTML data of the camera can be initialized and reboot of the camera can be performed onthis page.[Reset to the default(Except the network settings)]Click the [Execute] button to reset the settings to thedefault. Note that the network settings will not be reset.It is impossible to operate the camera for around 3 min-utes after the initialization.[Load the default HTML files(setup menu).]Click the [Execute] button to reset the HTML files to thedefault.It is impossible to operate the camera for around 3 min-utes after the initialization.[Reset to the default and load the default HTMLfiles.]Click the [Execute] button to reset the settings of thecamera and the HTML files to the default. Note that thenetwork settings will not be reset.It is impossible to operate the camera for around 3 min-utes after the initialization.[Reboot]Click the [Execute] button to reboot the camera. It isimpossible to operate the camera for around 2 minutesafter rebooting the camera.Note:• To initialize the network settings (☞ page 83), turnoff the power of the camera, then turn on the poweragain while holding down the [INITIAL SET] buttonon the unit for 5 seconds. Wait around 3 minutesafter releasing the button. The camera will start upand the settings including the network settings willbe initialized. Do not turn off the power of the unitaround 3 minutes just after turning on the power.• The notification function allows users to provide thenotification of the error to the specified destinationmail address and an original alarm destination whenan error such as no SD memory card insertion afterthe reboot or a locked SD memory card insertionoccurs. (☞ Pages 73 and 74)
