• Default: Off[Terminal 3]Determine how to use terminal 3.• Off: Not used.• Alarm inputSW559SW559SP509SP509SF549SF549SF539SF539 : Receives alarms. When “Alarm input” is selected, apull-down menu for “Close” and “Open” is displayed.– Close: An alarm is detected when the terminal status is changed to “Close”.– Open: An alarm is detected when the terminal status is changed to “Open”.• AUX output: AUX output will be supplied. The [AUX] buttons will be displayed on the “Live” page.• Default: OffIMPORTANT• In order for the EXT I/O terminals to detect alarm inputs when the terminal status is changed from Opento Close (On) or from Close to Open (Off), about 100 ms or more is needed. Because alarms cannotbe detected for about 5 seconds after a detection is made, alarm inputs received within about 5 secondsafter an alarm is detected are not detected.Note• AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the “Live” page.For example, an operator can remotely control lights in a place where the camera is installed byconnecting the terminal to the light controller.• Refer to the installation guide for further information about input/output rating of each terminal.[VMD alarm]When clicking “VMD >>”, the [VMD area] tab of the “Alarm” page will be displayed. (®page 122)[Command alarm]Select “On” or “Off” to determine whether or not to receive the command alarm.The command alarm is the function that provides notification of a Panasonic protocol alarm from the othercameras. When “On” is selected, alarm actions will be performed between multiple cameras.• Default: Off[Originating port number]Select a port number to be used to receive the command alarm.• Available range: 1-65535• Default: 8181The following port numbers are unavailable since they are already in use.20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 554, 995, 10669, 10670, 59000-6100013.2 Configure the settings relating to the alarmimage [Alarm]Click the [Alarm] tab on the “Alarm” page. (®page 46, page 48)The settings relating to the alarm image to be transmitted to an FTP server can be configured in this section.The alarm image will be transmitted to an FTP server. To transmit alarm images to an FTP server, it isnecessary to configure the settings in advance. (®page 144)IMPORTANT• Depending on the network line speed or the network traffic, images may not be transmitted at the exactdesignated interval or period.Operating Instructions 11513 Configure the alarm settings [Alarm]
