[Alarm image attachment]Select “On” or “Off” to determine whether or not to attach an image to the E-mail to be sent when an alarm isdetected.• Default: OffNote• The settings for “Image capture size” of the “Alarm image” section on the [Alarm] tab (®page 115) willbe applied to the size of the image to be attached.• When “3 mega pixel [4:3]” is selected for “Image capture mode”, images cannot be attached.Destination of notification[Address 1] - [Address 4]Enter the destination E-mail address. Up to 4 destination E-mail addresses can be registered.• [Alarm] checkbox: When the checkbox is selected, the E-mail notification will be performed upon an alarmoccurrence.• [Diag.] checkbox: When the checkbox is selected, the E-mail notification will be provided in the followingcases.– When notification of the remaining capacity of the SD memory card has been provided– When the SD memory card has become full– When the SD memory card cannot be recognized• [Destination E-mail address]: Enter the destination E-mail address.– Available number of characters: 3 - 128 characters– Available characters: Alphanumeric characters, the at sign (@), the period (.), the underscore (_),and the hyphen (-).To delete the registered address, click the [Delete] button respective to the desired address.[E-mail subject]Enter the E-mail subject.• Available number of characters: 0 - 50 characters[E-mail body]Enter the E-mail body.• Available number of characters: 0 - 200 charactersNote• Notification E-mail will be sent with the message “The capacity of the SD memory card is full.” whenthe SD memory card has become full, or “The SD memory card cannot be detected.” when mountingof the SD memory card failed.13.8 Configure the settings relating to Panasonicalarm protocol [Notification]Click the [Notification] tab on the “Alarm” page. (®page 46, page 48)Operating Instructions 12513 Configure the alarm settings [Alarm]
