[Close (Up to 5 characters)]Enter the name for “Close” of “AUX” on the “Live” page.• Unavailable characters: " &• Default: CloseNote• AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the “Live” page.For example, an operator can remotely control lights in a place where the camera is installed byconnecting the terminal to the light controller.13.7 Configure the VMD settings [VMD area]Click the [VMD area] tab on the “Alarm” page. (®page 47, page 49)The video motion detection areas can be set on this page.The VMD areas can be set up to 4 areas for each preset position (maximum 256 preset positions). Whenmotion is detected in the set area, it will be regarded as an alarm. The camera can be configured to take analarm action even when the camera is not at the preset position.IMPORTANT• The alarm occurrence indication button (®page 9) will be displayed when motion is detected by theVMD function.• The alarm occurrence indication button will be displayed when receiving an alarm input of a terminalalarm or a command alarm.• Depending on the network environment, notification may be delayed even when “Real time” is selectedfor “Alarm status update mode” on the [Basic] tab of the “Basic” page. (®page 53)• The motion detection function is not the dedicated function to prevent thefts, fires, etc. We are notresponsible for any accidents or damages occurring in case.Operating Instructions 13913 Configure the alarm settings [Alarm]
