Panasonic YD-350GL4 Operating Instructions Manual

Connection19Connecting jig(s)There are two types of jig terminals (Jig terminals 1 and 2)1 Jig terminal 1To send out a command for the emergency stop andtemporary stopping from a jig or another device.To send out the current detection signal to a jig oranother device.2 Jig terminal 2To install an external voltmeter or ammeter.Location: On the chassis inside the product.Note• Keep the communication cables away from the weldingarc area, the welding torch, the base-material-sidecable, etc. to prevent troubles caused by incorporationof the high frequency wave. And keep the wiring lengthwithin 10m.• Lead wires from the wiring port. (Make a cut in thegrommet wall to insert wires.)Layout of jig terminals* Connect the start signal of this product to the torch switch receptacle of the wire feeder.When touching a printed circuit board, observe the following item to preventelectrostatic destruction of the printed circuit board.Before starting an operation, for example, touch any metal part of the case with your handto discharge static electricity.As to signal wires from another device:make sure to tie the lead-in wires in a bundle witha binding band (15 cm) over the boot of thegrommet to prevent dust to get inWiring portTop view (without top panel)Location: On the chassis inside the product.65 55 50 51 128 83V +-55 5441 53 56＋15V105 107 101 100 81 80A- +106 107107 104 102103+CD (-) CD(+) -terminal.External terminalblock 2Externalterminal block 1