45. Network Monitoring Commands42745.15. config syslog host DescriptionThis command is used to configure the syslog host configuration. Formatconfig syslog host [ | all] {severity [emergency | alert | critical | error | warning |notice | informational | debug | ] | facility [local0 | local1 | local2 | local3 |local4 | local5 | local6 | local7] | udp_port | ipaddress[ |] | state [enable | disable]} (1) Parameters Specify the host index.all Specify all hosts.severity (Optional) Specify the severity level supported: emergency, alert, critical, error, warning,notice, informational, or debug.emergencySpecify emergency messages.alert Specify alert messages.criticalSpecify critical messages.error Specify error messages.warningSpecify warning messages.noticeSpecify notice messages.informationalSpecify informational messages.debugSpecify debug messages.Specify a level between 0 and 7.facility Some of the operating system daemons and processes have been assigned facility values.Processes and daemons that have not been explicitly assigned a facility may use any ofthe"local use" facilities or they may use the "user-level" facility. Those facilities that havebeen designated are shown in the following:local0 User-defined facility.local1 User-defined facility.local2 User-defined facility.local3 User-defined facility.local4 User-defined facility.local5 User-defined facility.local6 User-defined facility.local7 User-defined facility.udp_portSpecify the UDP port number.Specify the UDP port number.
