Panasonic hc-v180 Operating Instructions Manual

Also see for HC-V180: Basic owner's manual Basic operating instructions Basic owner's manual Owner's manual

Contents

- 65 -Message is displayed when this unit is moved rapidly.When “CAMERA PANNING IS TOO FAST.” appears, move the unit slowly while recording.≥ In the following cases, message will not appear:j While pausing the recording (only when [DEMO MODE] is not set to [ON])j When [LEVEL GAUGE] is set to [ON]This is for reducing the wind noise coming into the built-in microphones.≥ Switch to Manual Mode. (l 47)≥ This function’s default setting is [ON].≥ When switching to Intelligent Auto Mode/Intelligent Auto Plus Mode, [WIND CUT] is set to [ON],and the setting cannot be changed.≥ You may not see the full effect depending on the recording conditions.Recording setting of the built-in microphone can be adjusted.≥ Set [REC FORMAT] to [AVCHD]. (l 61)≥ [MIC SETUP] will become [STEREO MIC] when the [REC FORMAT] is set to [MP4/iFrame].[SHOOTING GUIDE]: [RECORD SETUP] # [SHOOTING GUIDE] # [ON][WIND CUT]: [RECORD SETUP] # [WIND CUT] # [ON][MIC SETUP]: [RECORD SETUP] # [MIC SETUP] # desired setting[STEREO MIC]: Sound from two directions is recorded in 2 ch by forward-facingstereo microphones.[ZOOM MIC]: Sound is recorded with changing the directionality in conjunctionwith the zoom operation. Sounds near the front of the unit arerecorded more clearly if you zoom in (close-up) and surroundingsounds are recorded more realistically if you zoom out (wide angle).MENUMENUMENU