ParaZero SafeAir M-600 Series Installation Manual

Contents

ParaZero SafeAir M-600 Series Installation Manual Manual pdf 17 page image

SafeAir™ M-600 Installation Guide 17 www.parazero.comSafeAir M-600 V2 AUTO-ARM model6Operating GuidelinesSafeAir M-600 V2 AUTO-ARM model6.1 PreflightInitial Conditions: The safety cover is on and the safety pin is in.Finalize all the preflight procedures to your drone and payload. The following tasks are inaddition to the regular preflight tasks – Check dampers not damaged Turn off the power to the drone Take off the safety cover Carefully remove the safety pin Turn on the power to the drone Go back to a safety distance of at least 5 meters6.2 Takeoff When climbing, you must climb to approximately eight meters before the system isarmed. Climb until you hear a single long beep, and the LED is GREEN. The system is now armed and ready for activation in case of an emergency.6.3 Before LandingWhen approaching landing, at approximately three to five meters from the takeoff altitude,the parachute system automatically disarms. At that point, a long double-beep is heard andthe LED is PURPLE..If the landing point is at a different altitude than the takeoff altitude, or the system did notdisarm for some reason in the air, which may occur when there is a sudden change inatmospheric pressure, land the drone slowly while keeping it level. After three seconds, thesystem disarms itself.6.4 After Landing First place the safety pin inside the canister. After the pin is secure, place the safety cover over the parachute system.Caution It is advisable to insert the safety pin back, before turning the drone’spower off. This will prevent unintentional parachute deployment