ParaZero SafeAir M-600 Series Installation Manual

Contents

ParaZero SafeAir M-600 Series Installation Manual Manual pdf 34 page image

SafeAir™ M-600 Installation Guide 34 www.parazero.comSafeAir M-60010Operating GuidelinesSafeAir M-600 model10.1 PreflightFrom the second flight and on.Initial Conditions: The safety cover is on and the safety pin is in.Verify "fire/activation" knob not in "fire" positionFinalize all the preflight procedures to your drone and payload. The following tasks are inaddition to the regular preflight tasks – Check dampers not damaged Turn off the power to the drone Take off the safety cover Carefully remove the safety pin Turn on the power to the drone Go back to a safety distance of at least 5 meters10.2 Takeoff Take off to an altitude of at least 3 meters above ground level. Arm the system by using the DJI extension’s arm switch: switch it up, wait 4 seconds andthen switch it down to its safe position again. Verify that the LED on the SmartAir turnsGREEN, followed by a beep. Important notice: The system will not arm if the Fire channel is activated. Make sure theFire switch is in its safe position and repeat the sequence.

/ 37

Related manuals for ParaZero SafeAir M-600 V2 Auto-ARM