ParaZero SafeAir M-600 Series Installation Manual

Contents

ParaZero SafeAir M-600 Series Installation Manual Manual pdf 18 page image

SafeAir™ M-600 Installation Guide 18 www.parazero.comSafeAir M-600 V2 AUTO-ARM model6.5 TroubleshootingSystem powers up and stays on red LED If the safety pin is still in place, remove it and perform a power cycle. Verify that the parachute connector is connected correctly. See SmartAir’s back sidesocket c on SmartAir Connectors Overview chapter. If the problem persists, contact Parazero for further instructions.System powers up and stays on yellow LED blinking once Check that both RC channels are in their safe (deactivated) position. Check that in the DJI Assistant channel configuration menu (Tools) both blue indicatorsare on their left side for the Fire and Arm channels. Check RC connector is properly connected to the SmartAir. Check channels are properly connected to the A3.System powers up and stays on yellow LED blinking twiceCheck the drone is level.System powers up and stays on yellow LED blinking 3 times SD card problem. Contact Parazero for further instructions.There are no audio indicationsCheck that the buzzer connector is properly inserted.System does not power upCheck that the power cable (coming out of the TerminateAir) is properly connected to theSmartAir.Fly Safely!Should you have questions, contact our support team at –support@parazero.comPhone – +972-36885252