ParaZero SafeAir M-600 Series Installation Manual

Contents

ParaZero SafeAir M-600 Series Installation Manual Manual pdf 26 page image

SafeAir™ M-600 Installation Guide 26 www.parazero.comSafeAir M-600 V2 model8.3 Before LandingWhen approaching landing, at approximately three to five meters from the takeoff altitude,the parachute system automatically disarms. At that point, a long double-beep is heard andthe LED is PURPLE..If the landing point is at a different altitude than the takeoff altitude, or the system did notdisarm for some reason in the air, which may occur when there is a sudden change inatmospheric pressure, land the drone slowly while keeping it level. After three seconds, thesystem disarms itself.Caution Failure to disarm the system before landingwill initiate parachute deployment, once power is cutoffIf the system isn’t disarmed, follow manual disarm:Disarm the system by flipping the Arm\Disarm switch upwards. Verify that the LED turnsPURPLE, and that you hear a double-beep. Now the system is disarmed. Wait 3 seconds, thenturn the switch down again. The LED will change to BLUE.8.4 After Landing First place the safety pin inside the canister. After the pin is secure, place the safety cover over the parachute system.Caution It is advisable to insert the safety pin back, before turning the drone’spower off. This will prevent unintentional parachute deployment