SNMP MIB ObjectsE-24 3160-A2-GB21-80March 1999Output Signal Table, RS-232-like MIBThis object contains entries for the output signals that can be asserted by the unitfor each of the synchronous data ports.Output Signal Table – “rs232OutSigName” (rs232OutSigEntry 2)This object contains the identification of a hardware output signal. Only thefollowing values are supported by the DSU/CSU. cts(1) – Clear-To-Send. dsr(4) – Data Set Ready.Output Signal Table – “rs232OutSigState” (rs232OutSigEntry 3)This object contains the current signal state. Only the following values aresupported by the DSU/CSU. on(2) – The signal is asserted. off(3) – The signal is not asserted.Output Signal Table – “rs232OutSigChanges” (rs232OutSigEntry 4)This object is not supported by the DSU/CSU.Generic-Interface MIB Extensions (RFC 1229)This generic-interface MIB is an experimental MIB that provides extensions to thegeneric interface group defined in MIB II. This MIB describes three tables: Generic Interface Extension Table Generic Interface Test Table Generic Receive Address TableOnly the generic interface test table is supported by the DSU/CSU. This table issupported for the network interface only.
