Configuration OptionsC-10 3166-A2-GB20-20March 1999Table C-3. General Configuration Options (2 of 2)TstDuration: 10Next Up Down Save PrevTest Duration. Specifies the duration (1 to 120 minutes) of user-initiated loopback andpattern tests. (The Tst Timeout configuration option must be set to Enab.) Use the left orright arrow key to position the cursor on the digit you want to change. Use the Functionkeys (Up or Down) to increment or decrement the digit.Up – Increments the test duration.Down – Decrements the test duration.Save – Stores the test duration.User Interface Configuration OptionsTable C-4. User Interface Configuration Options (1 of 6)Self-Test: EnabNext Enab Disab PrevInitial Self-Test. Specifies whether the DSU/CSU performs a device self-test at power-upand after a device reset.Enab – Enables a self-test.Disab – Disables the self-test.Dial-In: EnabNext Enab Disab PrevDial-in Access. Allows dial-in access to the DSU/CSU. For standalone DSU/CSUs,dial-in access is through the modem port. For carrier-mounted DSU/CSUs, dial-inaccess is through an external device that is connected to the communication port.Enab – Allows dial-in access to the DSU/CSU.Disab – Prevents dial-in access. Incoming calls to the DSU/CSU are not answered.NOTE: To enable Dial-In for carrier-mounted DSU/CSUs, the external device mustbe configured for automatic answer and the ComExtDev configurationoption must be enabled.Password: NoneNext None Com PrevPassword Mode. Activates a password prompt that prevents access until a password isentered.None – Does not require a password.Com – Prompts the communications port user to enter a password.Com Port: DisabNext Enab Disab PrevCommunication Port. Enables the use of the communication port.Enab – This communication port is enabled.Disab – The communication port is disabled.
