SNMP MIB ObjectsE-20 3166-A2-GB20-20March 1999 testSendV54Up – Sends a V54 up code to the remote unit. Only supportedfor the data ports. testSendV54Down – Sends a V54 down code to the remote unit. Onlysupported for the data ports. testSendFT1Up – ends a FT1 up code to the remote unit. Only supported forthe data ports. testSendFT1Down – Sends a FT1 down code to the remote unit. Onlysupported for the data ports.Where these object identifiers are defined as follows: testLoopDTLB – OBJECT IDENTIFIER ::= [wellKnownTests 2] testMonQRSS – OBJECT IDENTIFIER ::= [wellKnownTests 3] testMon511 – OBJECT IDENTIFIER ::= [wellKnownTests 4] testSendQRSS – OBJECT IDENTIFIER ::= [wellKnownTests 5] testSend511 – OBJECT IDENTIFIER ::= [wellKnownTests 6] testSendV54Up – OBJECT IDENTIFIER ::= [wellKnownTests 7] testSendV54Down – OBJECT IDENTIFIER ::= [wellKnownTests 8] testSendFT1Up – OBJECT IDENTIFIER ::= [wellKnownTests 9] testSendFT1Down – OBJECT IDENTIFIER ::= [wellKnownTests 10]Generic Interface Test Table – “ifExtnsTestResult” Object(ifExtnsTestEntry 5)This object contains the result of the most recently requested test. Only thefollowing values are supported by the DSU/CSU. none(1) – No test currently active. inProgress(3) – A test is currently in progress. notSupported(4) – The requested test is not supported. unAbleToRun(5) – The requested test cannot run due to the state of the unit.
