COMSPHERE 6800 Series Network Management System2-94 January 1997 6800-A2-GB31-20Daily Historical Utilization (dhu)Use the dhu command to obtain a report that displays the percent utilization of a group ofCOMSPHERE 3800/3900 Series modems for each hour of the day for a specified period of time.This report also lists the average number of calls that occurred for each hour of the day.Information is retrieved from the call statistics summary database.For most commands, NMS enables you to specify the destination for the command’s results andschedule its execution. If the last page of the input form cannot accommodate the Destination forresults and Schedule execution fields, an additional page is provided. For a complete descriptionof these fields, refer to Chapter 1, Introduction.Access Level: Help Desk, Data Technician, Manager, System AdministratorAbbreviation: Abbreviation: dhuRestrictions: Only Model 3811 modems are included in the data used for calculatingresults. If you specify another 3800 Series modem model number, theresults form will display a list of these modems indicating they are notincluded in the results.Routine: YesSchedule: YesRelated Commands: Call Occurrence Distribution (cod)Call Duration Distribution (cdud)Call Detail Display (cded)Daily Historical Utilization Input FormThis input form contains the following fields:Device(s) (Required field)Enter the device(s) for which call utilization statistics will be determined. One or moredevices may be specified. Standard addressing format applies to the input. Forinformation on device addressing, refer to Appendix D of the COMSPHERE 6800 SeriesNetwork Management System User’s/System Administrator’s Guide.REPORT PERIODEnter a report period for generation of the utilization statistics report. The report willinclude utilization statistics from the starting date to the ending date specified.Date(s) includedEnter a starting date and an ending date for utilization statistics information tobe reported.The valid format for the starting date is mm/dd/yy. The default is the previousday’s date.The valid format for the ending date is mm/dd/yy. The default is the previousday’s date.
