COMSPHERE 6800 Series Network Management System2-122 January 1997 6800-A2-GB31-20Display Call Directory (dscd)Use the dscd command to display the telephone numbers stored in the call directory of aCOMSPHERE 3800 Series modem, a COMSPHERE 3400/4400 Series modem equipped with aDBM, or a COMSPHERE 3600 Series DBM. To change the telephone numbers, refer to theChange Call Directory (chcd) command.The 3600 Series DSUs contain 10 entries, one per telephone number. The DBM-V option has only4 entries. For 3400/4400 Series modems, the telephone numbers are used by the Dial (dial) andStandby Facility (sf) commands to place calls and initiate backup.For most commands, NMS enables you to specify the destination for the command’s results andschedule its execution. If the last page of the input form cannot accommodate the Destination forresults and Schedule execution fields, an additional page is provided. For a complete descriptionof these fields, refer to Chapter 1, Introduction.Access Level: Help Desk, Data Technician, Manager, System AdministratorAbbreviation: dscdRestrictions: NoneRoutine: YesSchedule: YesRelated Commands: Change Call Directory (chcd)Clear Call Directory (clcd)Dialing (dial)Change Telephone Numbers (chtn)Display Telephone Numbers (dstn)Display Call Directory Input FormThis input form contains the following fields:Device (Required field)Enter the device for which the telephone number is to be displayed. Standard addressingformat applies to the input. For information on device addressing, refer to Appendix D ofthe COMSPHERE 6800 Series Network Management System User’s/SystemAdministrator’s Guide.Directory number (Required field)Specify the directory whose number should be displayed.For COMSPHERE 3400/4400 Series modems equipped with a DBM, valid entries arefrom 1 through 4.For COMSPHERE 3600 Series DSUs and 3800 Series modems, valid entries are from 1through 10.
