Standards Compliance for SNMP TrapsB-2 7984-A2-GB20-10February 1999linkUp and linkDownThe link SNMP traps are: linkUp – The unit recognizes that one of the communication interfaces isoperational. linkDown – The unit recognizes that one of the communication interfaces isnot operational.The network and synchronous port interfaces (physical sublayer) are representedby an entry in the MIB-II interfaces table and supported by the DS1 MIB.The following list describes the conditions that define linkUp and linkDown:linkUp/Down Variable-Bindings ifIndex (RFC 1573)This object provides the index into the ifTable and potentially into tables in other MIBs.The values of ifIndex are the same for all models, although not all indexes aresupported for each model.The ifIndex included with the trap consists of:– 1 COM Port– 2 HDSL Network Interface, Port 1– 6 DSX-1 Interface, Port 1 ifAdminStatus (RFC 1573)This object specifies the operational state of the interface:– up(1)HDSL Network: DSL link is established.DSX-1: No alarm condition exists.– down(2)HDSL Network: DSL link is not established.DSX-1: An alarm condition exists.– testing(3)A test is active on the interface. ifOperStatus (RFC 1573)This object contains the same value as ifAdminStatus. ifType (RFC 1573)This object is the type of interface:– T1(19)Used for the DSX-1 interface.
